What to do if the bathroom stores water

Recommended workaround:

1.Re-lay the tiles, pry up the tiles of the water storage part, and then redesign the inclination for laying, this method can solve the water storage problem at one time, but the daily use is affected during the construction period, and it is also labor-intensive and time-consuming.

2.Mop it dry with a mop, and when there is water storage in the bathroom, use a cotton mop to mop the water clean, but it is troublesome to drag it several times a day, and it can only be temporarily remedied.

3.Drainage, cut a shallow slit with a cutting machine at the water storage place, which can lead the water to the floor drain and discharge.

When decorating, we must do a good job of waterproofing the bathroom, the bathroom water needs to design a certain standard slope in order to flow the water into the drain as soon as possible, the general slope is large, the water flow is faster, and the slope is small, the water flows slower, regardless of the slope, the ground elevation needs to be 20-50mm lower indoors. The slope of the ground to the floor drain, that is, the slope of the entire drainage is generally about 2%-3%, in the backfill, leveling construction, it is necessary to radiate to the four directions with the floor drain as the center to find the slope, and the ground is required to be flat, the surface is free of pits, etc.

First of all, it is necessary to determine whether the water is caused by the leakage of the water pipe under the floor tiles or the water seeping through the brick joints to form water accumulation.

1) If it is the former, only find out the leakage and deal with the leaking water pipe.

2) If it is the latter, you can consider tightening the brick joints and washing the brick surface in time to avoid water seepage.

If there has been no shower, flushing and other water conditions, and the ground is kept dry, it can be judged that it is a problem with the water pipe under the brick, on the contrary, the possibility of water seepage in the brick joint is greater. As for the drainage of stagnant water, when the cause of stagnant water is solved, it will slowly and naturally dry up. Special attention should be paid to the gap between the corner between the bathroom floor and the wall, which often becomes a dead angle of the hook.

Unclog the floor drain so that it drains smoothly.

Almost all toilets are equipped with floor drains that drain water, and the floor drains are dirty and blocked, and if the drainage is not smooth, water will accumulate.

The floor in the bathroom is of different heights, and the drainage position is high, and the clean water cannot be discharged normally.

If you can't handle it yourself, you don't have to worry about it, and find someone who specializes in these jobs to deal with it.

If the bathroom is storing water because your sewer pipe is having a problem or is clogged, you can unclog the sewer pipe.

What to do if the bathroom stores waterThe water storage in the bathroom shows that its slope is not well found, well, around the floor drain, this slope must be found well, and he will not store water. If it's pure, there's no other way than to check it, unless you lay the floor tiles from there.

This is caused by a very tricky and careless reason.

I have had it before, the first time I did the bathroom, I didn't care, I let the repairman lay the floor tiles, and I haven't even done water treatment, and when I take a bath in the bathroom, there is a water leak down the first floor.

Therefore, the water treatment of the bathroom must be done.

The floor tiles must also have a slope so that the water can flow away quickly.

Now that the floor tiles have been paved, but the water is stored, it is better to pick them up and lay them again.

If you really don't want to, always prepare a dry mop, and when mopping the floor for the last time, use the dry mop to mop again.

That's all there is to it.

Adopt a friend.

Have time to chat.

You can go to the supermarket to buy a bag of decontamination powder to remove the dirt on the inner wall of the bottle, pour it or something, pour it at the mouth of the sewer, and then pour hot water down, and a chemical reaction will occur Because the water will flow down the sewer, it is not guaranteed that it can all reflect the cement block, but it can be changed to a small Repeat it a few times, and if it doesn't work, you can only go to the master who dredges the sewer.