-
Anonymous users2024-01-24White mist is a phenomenon caused by the liquefaction of water vapor into small droplets, so it must be caused by the water absorbing heat. I can tell you about substances that can release heat when added to water, such as sodium hydroxide and concentrated sulfuric acid, as long as you are careful during the operation, because concentrated sulfuric acid and sodium hydroxide are very corrosive!
The water in the toilet bowl is tap water and cannot be drunk directly, except for special circumstances, such as extreme thirst and lack of water.
Tell you: you have to put water to close the toilet bowl first, and it is best if you can allow more water. Then you gently press down, push to the bottom and pull up suddenly, being careful not to pull out of the water, otherwise the water will splash up, and after a few repeated strokes, your toilet will not be undredged no matter how firmly it is plugged. >>>More
1. Mix salt and vinegar together, stir, dilute the salt in vinegar, heat, dip the liquid with an absorbent sponge or rag, put it on the rust spot, and cover it for more than 20 minutes. Then use a coarse cloth dipped in a salt and vinegar mixture and scrub vigorously to remove. >>>More
For this question, you can first use a piece of paper to put on the water in the toilet bowl and try it.
Fill a large Sprite bottle with tap water, close the lid and crash it into the toilet bowl to flush it.