The walls around the 3D living room have been extruded, how to guide the TV background wall in CAD t

Updated on Living room 2024-06-27

3 answers

Anonymous users2024-01-24

The TV background wall can also be imported in the same way.

It's just that the position is wrong, you just need to put the position appropriate.
Anonymous users2024-01-23

It's also a guide, but you probably can't find it, right? Just find it and adjust it.
Anonymous users2024-01-22

Then just go ahead and pour the CAD into 3D and adjust the position yourself.

Related questions

After decoration, what should I do if the bottom of the living room wall is damp and peeling?

2 answers2024-06-27

Moisture, indicating moisture. Check the source of moisture, especially the embedded water pipes in the ground, kitchen and bathroom spaces, etc. I can explain your specific situation and help you see.

How to measure the wages around the living room ceiling hanging by meters

1 answers2024-06-27

Make a table. Add. Then calculate a reasonable amount of labor cost according to the number of labor users and labor time. >>>More

The living room is 5 meters long, 4 meters wide, 4 meters high, 3 meters high, and is surrounded by

1 answers2024-06-27

335 sheets for the ground, 16 * 12 = 192, wall (16 + 36 on both sides, 300 * 100, 9 sheets, a total of 335 sheets.)

The living room is 6 meters long and 3 meters wide with 7 meters of suspended ceilings around it, an

1 answers2024-06-27

You can ask about carpentry about this, and in general, yes. >>>More

3D cross-stitch, is it good to embroider? How does it look when hung in the living room? Which is th

4 answers2024-06-27

The simple embroidery of 3D is fast, and the picture also has a sense of layering. To a large extent, the whole embroidery is a sense of accomplishment and the workload is large, so the selling price of the finished product will be higher, and the 3D is focused on the simple finished product, and the decorative effect is not worse than the full embroidery if you use it at home.