-
Anonymous users2024-01-24When installing an electric water heater, the length of the connection between the water heater and the water intake point should be shortened as much as possible. The water heater should be installed in a position of at least 250mm up and down, and at least 700mm on the front and side of the water heater for future maintenance.
The key depends on your use environment and conditions, the grid conditions allow the optional instantaneous faucet (about 3000W), ready to use, or use the kitchen treasure (a small electric water heater with a capacity of less than 10L), to see that the upper outlet is installed under the cabinet is more beautiful.
If you want to control each other, just connect the hot water pipes. But I advise you not to connect, two water heaters gas water heaters for the vegetable basin hot water, electric water heater bath, so that you can save water and electricity, do not pre-drain a lot of cold water,.
That's a great question! As a designer, it makes sense for him to design this way, but if you take safety into account, my suggestion is that it is best to install it outside the shower room, and of course inside the integrated ceiling (the display screen is exposed), which is just to extend a section of the waterway. Because many building bricks are not strong (even hollow bricks), storage electric water heaters are stupid, big, stupid, and coarse, and filled with water for a long time.
As long as there is room on the top, it can, but it can't be gas-used, and there should be a maintenance opening. Many hotels are located on top of the toilets.
There is no problem, but it must be considered that the maintenance is convenient, the ceiling can be opened at any time, especially the maintenance end on the side should leave a certain space.