-
Anonymous users2024-01-241. When paving the tiles of the bathroom, the cement should be full and the amount of cement around the tiles should be about the same, so as to ensure that the tiles are firmly glued to the wall and will not appear hollow.
2. How to ensure that the tile is paved and smooth? Experienced decorators will use a plastic hammer to beat the surrounding areas of the tiles to control the surface flatness of the tiles in time. Otherwise, it will be too late to adjust the cement dry, if the paving of the bathroom tiles is not adjusted in time, it will lead to the paving is not smooth enough, the edge is slightly higher, and the shower room has to be "deformed"!
3. Tiles need to be tested to see if they are vertical, and the method is to carefully measure the verticality of each tile to ensure that all tiles are firmly sucked on the wall. If the decorator's craftsmanship is poor, the gap between the tiles will be large.
4. If you want the tiles to stick firmly to the wall, you must make the outer edge of the tile and the wall full of cement after the tile is pasted, so that the tile will be more firmly glued.
If the edge of the tile and the wall are definitely not filled with cement, it will cause a small piece of the edge of the tile to fall off if you accidentally touch it!
-
Anonymous users2024-01-23After the tile is paved, most of the unevenness is caused by the uneven application of cement mortar, or the uneven base surface itself, if the tile adhesive is used for construction, this situation will be greatly alleviated. Because the tile adhesive is scraped directly on the base surface, and then the tile is kneaded and pressed on, the water retention is very good, and the shrinkage is not large, so there will be no unevenness.
The following is the detailed construction method of tile adhesive:
1. Pour the porcelain sticker powder into clean water and stir it into a paste (mixing ratio: 20kg powder 6kg water), after stirring, it needs to stand still for about 10 minutes, and then stir slightly before use, which helps to increase the adhesion force.
2. Use a toothed scraper to apply the glue on the working surface to make it evenly distributed and form a toothed shape.
3. Knead the tiles on the top during the drying time.
First, do a good job of wall waterproofing (ordinary wall not less than 30 cm, shower area not less than 180 cm), then hang net plastering (to ensure that it does not fall off, hollow), and then paste the wall tiles with tile adhesive. >>>More
1. Before tile paving, standardize the acceptance and reasonable protection of the waterproof layer and water circuit transformation to prevent damage to the tile during construction; >>>More
1. Sold with patterns; 2. It can be interspersed with white, or red and yellow.
1 Tile dislocation paving.
If the tiles are misplaced, then the floor drain can be cleverly installed at the intersection of the tiles, with the advantage of not destroying the tiles. >>>More
In daily life, the rice soup and noodle soup that are often ignored can remove the oil stain on the kitchen tile, the viscous rice soup is smeared on the oil stain on the tile, and after the rice soup is condensed, gently scrape it with chopsticks or flakes, the oil stain will be attached to the rice soup and be scraped off together, the material is simple, the operation is trouble-free, and the effect on the stubborn oil stain on this kind is significant, but because the rice soup is not easy to retain for a long time, it can not be used at any time like other methods. >>>More