-
Anonymous users2024-01-241. All if the upper and lower width of the inclination does not exceed 4cm, there is generally no problem and can be customized normally.
If the upper and lower width is more than 4cm, it is necessary to measure accurately, and the specific data comes out, and then we will add one more aluminum or lengthen one of the track materials according to the actual error, which is not too difficult and easy to do.
The key is to get the size accurate.
Please add door edge strips to achieve a sealing effect.
Plastic edges can be installed at the joints of the door edges. >>>More
The installation of shower rooms in many factories may be different, but the general direction is the same, first of all, prepare the tools to be used: screwdriver, impact drill, electric drill, air batch, rubber hammer, glass glue, glass gun, positioning level, tape measure, etc. The steps are as follows: 1, install the aluminum on the following and the left and right sides, install the fixed glass, and then install the aluminum on the top, fix the screws, 2, and then move the shower room and put it on the bottom stone, and then install the aluminum on the wall, mark it on the wall, and then lift the shower room to one side and put it against the wall 3, do a good job of positioning it with a level, and then fix the aluminum on the wall, and then lift the shower room up and install it, and fix the aluminum on the left and right sides and the aluminum on the wall. Then install the pulley on the movable glass, hang it on the aluminum material and fix it, then adjust the movable screws of the upper and lower sliding wheels, adjust the high bottom, and make it firmly fixed in the slippery water of the upper and lower aluminum. >>>More
It is recommended not to install it directly above the shower room, it will be very hot on the head, and the AIA dry and wet zonal heating system I installed is a little more convenient, you can adjust the temperature by yourself, and it will automatically cool down if it is high.
How to install the rope on the glass door of the shower room? After drilling with a glass drill bit, put on the rope, fix it and reinforce it with glass glue. Remove the three screws of the vertical side branch (column). >>>More
Who said that the bathroom shower room must be equipped with a glass door, the glass door is difficult to clean, there are certain safety hazards, and there is no privacy at all. Therefore, like my home, I directly install a closed sliding door, all problems are solved, washing and bathing do not interfere with each other, and it is very convenient to use. The black and white sliding doors are simple and beautiful.