-
Anonymous users2024-01-24According to the size of the wall, then subtract one centimeter to be OK, the length to subtract one centimeter, and the height to subtract one centimeter. I mean, if the balcony is not tiled, it is necessary to apply foaming agent and glue when installing, and subtract one centimeter is just right. More is not sealed, less is not easy to install. Hope to adopt.
-
Anonymous users2024-01-23The area must be calculated if the balcony has a cover and a maintenance structure (railing) on this floor.
1. About the enclosed balcony. The so-called closed balcony is a balcony with glass or plastic steel windows. However, it must be a closed balcony with planning approval documents or construction drawings approved by the planning department to be fully counted.
Otherwise, it is only one or two thousand to seal a balcony made of plastic steel, and the extra three or five square meters are worth more than 100,000 yuan in a big city.
2. Unenclosed balconies are calculated as half of the horizontal projection of the upper cover in the maintenance structure.
A, if the upper cover is spanned, for example, the balcony is on the third floor, but its cover extends from the ground on the fifth floor, then the balcony is not counted as an area.
B. If the horizontal projection of the upper cover is less than half of the area of the balcony floor, then the entire balcony is not counted as an area; If the horizontal projection area of the upper cover is less than the area of the balcony floor but greater than half of it, it shall be calculated according to half of the horizontal projection of the upper cover.
-
Anonymous users2024-01-22When installing doors and windows by wet method, the size of the installation gap between the door and window frame and the opening wall should be specifically determined according to the thickness of the decoration material of the surface layer of the opening wall, which can generally be used in the following table: Table Installation gap between the door and window frame and the opening wall (mm) Surface layer decoration material Steel structure Clear water wall Veneer brick Stone board Gap size 5 (2 5) 15 (10 15) 25 (20 25) 50 (40 50).
When installing doors and windows by dry method, the size and burial depth of the embedded attached frame should be specifically determined according to the thickness of the decorative material of the surface layer of the opening wall; or the size of the rear frame of the opening wall and the installation gap between it and the opening wall (generally 5 10 mm can be adopted). The size of the installation gap between the door and window frame and the opening embedded frame and the rear frame can generally be adopted as 2 4 mm.
The above is the acceptance specification of aluminum alloy doors and windows, and others can be referenced.
The window is surrounded by 8 thick insulation layers, install 10 thick expansion screws, definitely not, high-rise sealing, must be absolutely safe, when encountering strong wind and rain, the outside will shake, only 2 thick screws in the brick, definitely not strong, the foam layer is not strong, it is recommended to use more than 15 expansion screws, the feeling will be firm, otherwise, the gains outweigh the losses, fall down and hit people, you will regret it for a lifetime.
Use half of the tile as the corner line and stick it to the wall.
There will be people around you who have a sudden rebound in temper! Obedient and obedient people will suddenly have a volcanic temper to scare you today!
It doesn't matter, the study just pays attention to Wenchang.
The air is not circulated, the sun is not sufficient, and the vegetables themselves cannot be absorbed by the daily watering, and they accumulate like this.