Put the moldy noodles in the kitchen sink, do you have aflatoxin in the sink, and how to remove the

Updated on Kitchen 2024-06-23
4 answers
  1. Anonymous users2024-01-24

    Aflatoxin is very difficult to kill with high temperature! It must be above 280 degrees to kill 90%.

  2. Anonymous users2024-01-23

    If you don't eat moldy noodles, you should be fine, dilute and clean the pool with mold water and scald it with high-temperature boiling water.

  3. Anonymous users2024-01-22

    As long as you don't eat moldy food, you'll be fine! Trace molds are everywhere!

  4. Anonymous users2024-01-21

    Some. Buy a bottle of Basi. Boil some boiling water. 84Pour it into boiling water. Then wipe the pool again. That's it.

Related questions
How do you get water when noodles are poured into the kitchen sink?
2 answers2024-06-23

If the noodles are poured into the kitchen sink and cause blockage, you can use a tool that leads to the pipe.

What should I use for the gap between the pipe and the sink in the kitchen sink, the original one is
2 answers2024-06-23

It is better to use silicone glue, and it is used to fix it on the construction site, which is cheap and practical.

At noon, I cooked the noodles while cooking in the kitchen, and then went back to the house to play
3 answers2024-06-23

That's why you're suspicious, and that's understandable, because this is what you're cooking, it's boiling for a long time, and then there's a kind of pressure in that pot, and when the pressure reaches a point of expansion, it's going to move things around it, so it's very scientific, there's nothing to be told, and you can try again tomorrow and think what I'm saying can be taken lightly.

There was a leak in the dishwashing area of the kitchen at home, and the drain next to it was filled
2 answers2024-06-23

First see if the elbow of the sewer pipe is blocked

The sink in the kitchen is often overflowing with water, and what to do with it can stop the water f
1 answers2024-06-23

This is the phenomenon of flooding, because the sewer pipe does not flow enough when the pool is discharged. Use a PE pipe with a diameter of 50---60 cm, insert it into the sewer nozzle (the surrounding gaps do not leak water, sprinkle a little), and the PE pipe can be 10---20 cm above the ground.