-
Anonymous users2024-01-24You may have two reasons, one is that the bathroom may not be waterproofed properly and leaking. The second is that you are a layer, it is possible that the ground is too damp, and the bottom is not dry and the putty is scraped.
-
Anonymous users2024-01-23Remove the wall skin and re-scrape the putty.
1) The conductor has quality problems or the insulation layer is damaged, and the leakage trips. >>>More
Most of your phenomenon is related to the virtual connection or disconnection of the neutral line, because the neutral line is broken, and there are electrical appliances plugged into this road (the sockets in the living room and three bedrooms) that cause voltage on the neutral line. Unplug the electrical appliances from the sockets in the living room and three bedrooms and try again, so find out the zero break point (virtual contact), tighten the screws on the binding post, and the fault may be eliminated.
It doesn't matter, as long as the water on the ground rail is cleaned up when it is installed, and then a layer of glass waterproof glue is placed underneath, I hope it can be adopted.
If you go to measure it again, how can you reserve a distance of half a meter.
It's hard to change after the decoration is done, so you can only find something to block. My house too, the kitchen is directly facing the bedroom. I'm going to put a potted plant, and then hang a few gourds, and it must be a black stone. It's just that the price is expensive. There are also crystal curtains that you can hang, and if you are willing to do so, you will be equipped with black yaoshi, it is recommended.