-
Anonymous users2024-01-24The biggest possibility is that the main pipe connected to the sewer of your toilet is blocked, or it is not smooth, resulting in the flushing of the entire unit cannot be discharged smoothly and squeezed into the diversion pipe of each household, so there is a phenomenon of water or splashing water into the home.
The reason for the cooing is that the sewer of the toilet is a U-shaped structure, and there is water in the U-shaped structure for a long time, in order to prevent the biogas from backing up into the room, because the main pipe circulation is not smooth, resulting in the air pressure in the hall is unpredictable.
Therefore, occasionally I hear the sound of gas pouring into the room in the pipe, especially when flushing, because the flushing is equivalent to putting pressure on the main pipeline, when the main pipe is not smooth, the air inside is squeezed due to the incoming water, which increases the air pressure in the pipe, and will also form the gurgling sound of gas backflow.
Precautions for the use of toilet pipes.
When installing toilet water pipes, it is necessary to pay attention to the direction of the water flow, generally follow the path from the top to avoid damage during construction, and ensure that the pipes do not cross as much as possible, especially the hot and cold water pipes should be separated by a little distance. Try to avoid corners and curves, and if you must set up, you should use a special corner pipe interface to facilitate the maintenance of pipeline blockage in the later stage.
When installing the water pipe, groove in the wall and bury it in the wall, and then follow the normal construction process, the hole of the hot and cold water pipe is installed at a distance of 10 cm next to the sink, which is generally hot on the left and cold on the right. The height of the water pipes in the shower area is between 2 meters. There is no need to arrange hot water holes next to the toilet, and cold water holes can be reserved if you need to install a washing machine in the bathroom.
-
Anonymous users2024-01-23I'm dizzy, I don't even know this, it's blocked, and the gurgling sound is because the water is not smooth
I suggest using AB glue to seal the leakage, and then rebuild it with the leak plugging spirit.
Remove the floor, repair or replace the leaking pipes. Then restore the floor. I hope my answer can help you.
There is gas in the pipes and there is no trap in the sewer pipes. I hope my answer can help you.
If it is a cast iron pipe and has trachoma, you can find an aluminum strip or wire, stick it through the hole, and gently tap it with a small hammer (cold worked, riveted), or you can use a hose clamp to put rubber on the inner part of the hose hoop, clamp it tightly with a hose hoop, or use a sawdust to drive it in (there is no pressure in ,--the drain pipe), and it will not leak in a short time
1. Shove a few times with a pickpocket, and there is one sold in the supermarket"Pipe pass"It works very well, and it is only about 10 yuan. >>>More