How to make a beautiful sewing agent in the living room

It's not toxic, just wipe it with your fingers, and you'll be fine. Nothing "professional".

The crevices should be cleaned and dried.

1. Prepare materials such as sewing agent, glue gun, scraper, sponge, brush, wallpaper knife and masking paper.

2. First use caulk or white cement to pave the bottom and fill the joint, and at the same time press out (scrape out) 1 groove to keep the tile joint depth of about 2-3mm.

3. After the bottom caulking is completed, the cement in the tile joint is dry, and the dust in the tile joint is removed with a vacuum cleaner or brush, and the brick joint does not fall off the powder, so that the joint construction of the beauty joint agent can be carried out.

4. Put the sewing agent into the glass glue gun, then install the white discharge nozzle, use a knife to cut the discharge nozzle into a 45-degree slope angle, the width of the discharge nozzle should be basically consistent with the width of the seam, and the discharge nozzle should be completely lying in the seam, leaving a gap of 2 mm deep.

5. Before the construction of the sewing agent, use a rag or a fine brush to clean up the dust and other magazines in the seam.

6. Paste masking paper on both sides of the sewing. The masking paper should be left and right from the edge of the gap.

7. Evenly drive along the brick joint, about 1 meter for construction, and immediately apply it evenly with a finger or a small scraper; When the sewing agent has not solidified (about 1 meter of construction), remove the masking paper with your hands.