-
Anonymous users2024-01-23The water heater can be installed in a ceiling hanging.
As long as it is a floor slab, the stainless steel frame can be fixed.
The hanging type is just as beautiful and firm.
How to install a wall-mounted water heater on a red brick hollow wall?
Answer: You can only buy that kind of small fast-heating water heater, otherwise there is no way, if you use a volumetric water heater, it is recommended to change the water circuit on the line, now your wall is a hollow brick, if the water and electricity are still being done, the bathroom wall will generally have one or two walls is a force reduction wall, it is best to check whether the hanging wall is hollow brick decoration wiring before.
How to hang a water heater on a hollow brick wall.
How to solve the hanging electric water heater of hollow brick wall?
Tools: percussion drill, 300*10 drill bit, wrench and other materials: long bolts (wall thickness + 40mm), nuts, gaskets, method: first according to the location of the water heater installation hole, determine the drilling position and quantity on the wall.
At the determined location, a percussion drill is used to drill through the wall hole (through hole).
After the drilling is completed, insert the bolts, put on the water heater, pre-tighten one end of the water heater first, and then add a gasket to tighten it at the other end.
Advantages: It can carry large loads, solid and reliable.
Disadvantages: Affects the aesthetics of the other side of the wall.
Hollow wall mounted electric water heater?
Recommended answer: There must be another line of defense, it is recommended to use expansion bolts, which are easy to fall off, and then get a tripod to fix under the water heater to ensure that the water heater will not fall off the hollow wall It is not safe to install the electric water heater, that is, the water heater is installed.
-
Anonymous users2024-01-22Hello: Glad to answer for you:
The water heater can be installed on the roof of the shed, as long as the floor slab can be fixed stainless steel frame, the hanging type is as beautiful and firm.
- I hope I can help you, and if you are satisfied, you can adopt me. Thank you.
-
Anonymous users2024-01-21Nowadays, most water heaters are installed outdoors (small balconies in the kitchen).
-
Anonymous users2024-01-20On the ceiling, if it is not good to fall off, and the water heater is not heavy, you can try butterfly expansion.
Use wall screws to drill holes with steel plates on both sides, and then use nuts to press on both sides, the bolts should be long enough to penetrate the wall, and there should be a certain remaining size enough to hang the water heater, I hope it can help you.
Hit deeper, use expansion screws.
Your analysis is right, if the pipe leaks, it should be more and more leaky, and it will not dry out, your situation may be that it is raining outside, the wall is shaded with water, and then observe it when it rains.
It is installed on the wall tiles, and most of them are pasted with wall tiles first, and then installed with water heaters.
This is more troublesome Two schemes 1: You can measure the size of the hollow brick to make a big hole Fill in the sand ash with a higher mark The size should be measured The brick is pasted and then the water heater is no problem 2: This scheme must be the partition wall is your own room Use the screws through the wall to pass the wall through the other side of the wall with a steel plate Drill holes on the other side of the wall and then use a nut to screw on the other side to fix the water heater bracket Okay, I don't understand and ask again I hope it can help you I am specialized in installation.