Can you install the kitchen sink by yourself?

Measure the location of the drain first, whether it is in the shower room. If you don't have it inside, you can't fit it. Generally, the size of the shower room is 900x900, 1200x800, 1000x1000

Measure the size and then go shopping. Otherwise, it will be very troublesome. As a reminder, you can only install the one with a back panel, because you can't install a shower mixer.

However, you may also be able to choose a shower plate.

Hello! Prepare before installing the sink

Before installing the sink, both the faucet and the inlet pipe should be installed.

When installing faucets, it is not only required to be installed firmly, but also that there should be no water seepage at the joints.

Once you've installed some of the sink's functional accessories, it's time to place the sink in the countertop and ready to start the next step of the installation process.

Method of installing the pool

Install the water inlet pipe of the faucet Connect one end of the water inlet pipe installed on the faucet in advance to the water inlet switch, pay attention to the firmness of the connection when installing, and also pay attention to a detail, that is, the location of the hot and cold water pipe, do not confuse the left and right.

The sewer pipe with the overflow hole is a protective hole to avoid the overflow of the sink, so when installing the spill sewer pipe, it is necessary to pay attention to the tightness of the connection between it and the tank, and to ensure that the sewer pipe of the overflow hole does not leak itself.

Install the sewer pipe under the filter basket When installing the sewer pipe under the filter basket, the main attention should be paid to the connection between the sewer pipe and the tank, which should not only be firm, but also sealed.

Install the overall drainage pipe Usually people will buy a sink with two filter baskets, but the distance between the two sewer pipes is far away, and the workers will cut the matching drainage pipe according to the actual situation when installing, and pay attention to the sealing between each interface, and the common water leakage problem occurs at these joints.

After the sink is put into the countertop, it is necessary to install a matching hanging piece between the tank and the table top to install the sink firmly to avoid small gaps that cause the tank to shake left and right.

Installation acceptance

After the basic installation, the filter basket is also installed and the next step of the experiment begins.

To do the drainage test, it is necessary to fill the sink with water and test the drainage of the water from the two filter baskets and the overflow hole at the same time.

When draining, if there is water seepage, it should be reworked immediately to ensure that it is not hindered in future use.

Once the drainage test has been carried out, the sink can be edge-banded to ensure that there are no problems.

When using silicone edge banding, it is necessary to ensure that the connection gap between the sink and the table top is uniform, and there can be no water seepage.

After sealing the edges, the installation of the pool is complete.