-
It was the water vapor that ran to the LED lamp, causing the zero electricity and zero line to be electrified, and after a while, because it was also air-dried, it returned to normal.
-
Check the circuit to see if there is any bad contact.
The switch bus is disconnected, and there is electricity in the lamp head, and the electrician may connect the live wire to the lamp head.
Do you have a separate circuit in the bathroom? If it is set separately, then don't push the air switch in the control toilet at the moment, and then send the beam to roll and push the gate knife up again. If you don't open the light switch in the bathroom, it won't jump, then there is a problem with the wiring of the bathroom. Dust remnant.
It should be that it is not tight enough when twisting and causing it to loosen! This kind of problem doesn't matter much, because if you are disrespectful, he is naturally easy, due to pressure, it becomes loose and causes the power to be connected for a while.
The first is that the bulb is broken. The second is that someone in the family fiddles with electrical appliances and causes a short circuit. There is also a power outage and maintenance of the power supply bureau.
, the rubber ring inside is broken, unscrew the faucet counterclockwise, find a waste inner tube, scissors cut a rubber ring, and replace it. Or just get a new faucet.