-
Anonymous users2024-01-24Hello dear! 1. When we install the check valve, we must first close the toilet water valve. Let's just tighten the valve clockwise.
2. Then disassemble the toilet inlet pipe. We use a wrench to clamp the inlet pipe to fix the suffocation nut and loosen it, separating the toilet inlet pipe from the water valve. 3. Install a water stop valve.
We need to prepare a laughing bending check valve with the inner filament flowing to the outer filament, and then rotate the check valve to screw the lead inlet valve outlet, and we can wrap several turns of raw material tape around its thread buckle during installation. Finally, we can connect the toilet inlet pipe to the other end of the check valve. Hope it helps!
-
Anonymous users2024-01-23In addition to the general valve installation matters that need attention, the installation of check valve also needs to pay attention to the installation direction and maintain the valve body action space. The lifting horizontal flap check valve can only be installed on the horizontal pipe, and the swing check valve can also be installed on the horizontal pipe.
1. Protective measures should be taken for the flue during vertical transportation, and it must be bai >>>More
There are various products on the market, the principle is very simple, the key is to be durable, the check valve used is easy to be polluted by oil smoke and lead to performance degradation.
It is the movable page fan of the check valve that is stuck, and the only way to repair it is to remove the exhaust pipe of the range hood to repair it.
Kitchen sewer pipes are generally not installed with valves, because kitchen waste contains sundries, which is easy to block the pipes, and the valve core of the valve is more likely to block the pipes when installing valves.
1. Before the installation of the toilet, check whether there is any blockage of sediment and debris in the sewage pipe, and whether the installation ground is level. The toilet sewage pipe should be made of plastic pipes required by the national standards, and the inner wall of the pipe should be smooth, flat, no bubbles, no cracks, no obvious marks and depressions. In particular, it is necessary to ensure that the sewage pipe is about 10mm above the ground. >>>More