Is it feasible to change out a bathroom in the room?

But you can, but there must be a bathroom that is cushioned, such a situation you can see in many tea rooms, it is more troublesome to walk down the sewer pipe, but as long as the pipe is worn and waterproofed, there is no problem. It's just that the ventilation and lighting of this bathroom are not easy to get, LZ should think clearly.

The sewer of the second toilet can only be connected to the first toilet on the ground of your house, otherwise the lower class people may not agree. Sheung Shui is easy to do. In this way, the second toilet must be raised.

It is feasible within 5 meters, and it is easy to have problems if it is greater than 5 meters, and everything else is not a problem.

The room is generally more south-facing, and it is difficult to raise the ground by more than 200mm to connect the sewage pipe; If you don't need a toilet, only solve the problem of men's showers and couples, you can pre-bury water, electricity and sewage pipes before laying floor tiles.

It is feasible, but one is that the toilet may be higher than the other, because we have to walk the drainage system from the ground, and the second is that the drainage system takes the bright line, if the layout is good, the effect is that the toilet is a little higher, and the drainage system should be distributed to the floor drain

It's okay to have enough space, but it's best not to face the bathroom.

1 Your idea bai is basically feasible, but test du

It's not perfect. Xiao Zhi Woji Dao is square, adding a small bathroom in the back room.

The room was difficult to set up. Appearance.

2. The key to changing the toilet is how to go through the drainage pipes: the drainage of the A flat floor needs to raise the ground by at least 20 cm, and the distance from the original drainage main is not more than one meter. B: The drainage on the lower floor is the most reasonable, but it depends on the situation downstairs.

3. The most suitable bathroom for your apartment is the cloakroom you said, if you are on the first floor, you can directly change the cloakroom to the bathroom, using lower drainage.

Personal suggestion: Since your original bathroom area is still not small, you can divide the original bathroom and toilet into two parts to form two toilets.

A look at the structural drawing, if the wall of the small bedroom can be chiseled to the right to open the door, then divide the inside of the original bathroom into a small piece for the small bedroom.

If the small bedroom cannot open the door to the right wall, you can consider dividing the bathroom into two parts, and the upper part will open the door to the dining room.

OK.

The room generally faces south, and the ground needs to be raised more than 200mm to connect the sewage pipe, so it is more difficult32313133353236313431303231363533e78988e69d8331333365643662; If you don't need a toilet, only solve the problem of men's showers and couples, you can pre-bury water, electricity and sewage pipes before laying floor tiles.

First of all, re-do the ground waterproofing on the third floor, and then disconnect the water supply and drainage pipes from the first or second floor and connect them directly.

In general, two holes should be opened in the ground of the third floor to the second floor (for drainage), so that the roof of the second floor is destroyed, and if the structure of the house is strong enough and the floor is high enough, the floor of the bathroom on the third floor can be padded up about one step high, so that the roof of the second floor is not destroyed.

Special attention: 1. Waterproofing must be done well, 30-50 cm above the ground;

2. If the third floor is a wall (bathroom partition wall or other walls), it must be in the same position as the wall downstairs, and lightweight materials should be used as much as possible. If the quality of the building is slightly poor, it will affect the structure.

At present, there are two common methods for laying water pipes in bathroom water and electricity renovation, one is to level the ground first and then open the pipe groove, bury the water pipe in it, and then use mortar to level the pipe groove; The other is to lay the water pipe directly on the ground and then use mortar to level the ground and cover the water pipe. Yours is obviously the second type, since the water pipe has been laid, then it is enough to level it with mortar, and then it is okay to do the waterproofing normally.

Bathroom waterproofing, generally we will directly recommend the use of mortar waterproofing agent, not only with the base surface sticky firm, and high puncture strength, can be the same life as the building, simple construction, cost-effective is now the preferred material for home decoration waterproofing. It is necessary to pay attention to the construction according to the product construction instructions, so as to ensure a good waterproof effect.

I also have the same idea, the new house is 120 square meters, there is only one bathroom, I want to add another bathroom, the small bathroom is only enough to install a squat, who has a good way, specifically, thank you!

Not recommended, not recommended.

The drainage is not easy to solve, and it is easy to block if it is not done well. At that time, it was too late to regret it.

Waterproofing is a very troublesome project, if you don't get it right, you have to pay downstairs if you wet your home.

I recommend not to change, 1Peculiar smell 2The toilet is flushed too loudly.

It's easy to pee, but you can't get a big one, unless you install a lift pump.