-
Anonymous users2024-01-23What you said is too general, it is better to have pictures, to see where they are leaking, what is the state of leakage, and under what circumstances there will often be leaks.
-
Anonymous users2024-01-22Bathroom and kitchen leakage can generally be divided into three situations: waterproof layer damage, drain pipe leakage, and water supply pipe leakage
1. Judgment of waterproof layer damage: plug the floor drain, and then release water on the ground, pay attention to observe the water leakage downstairs after 30 or 40 minutes, if the water leakage downstairs is serious, it is determined that the waterproof layer is leaking.
Treatment: Use Anju water without leakage. Through the penetration of a water carrier, a permanent waterproofing layer is formed below the tile surface.
2. Judgment of drain pipe leakage: drain to the floor, fill the hand basin, and flush the toilet repeatedly to see if the leakage downstairs is aggravated.
Solution: Replace the sewer pipe, try to plane as few bricks as possible, and finally need to redo the waterproofing on the ground.
3. Judgment of water supply pipe leakage: If the water leakage is uniform and continuous, turn off the upper water, and the water will be reduced and will not leak.
Solution: Replace the water pipe.
Tools Raw materials.
Water does not leak plastic buckets, brooms, rags, tool knives, and shovels.
Method steps.
11. Clean the bathroom floor.
2. Use a tool knife to cut the tile joint.
3. Use a rag to block all the floor drains in the bathroom. Note: If it is squatting, use gypsum powder and water to adjust it into a dry mud shape, and surround a 3 cm high retaining wall on the squatting toilet (to prevent water from leaking liquid material from flowing to the sewer pipe, and the sewer pipe is blocked), and the toilet is not used.
If there is no doorway stone or the doorway stone is too low, this method can also be used.
4. Fill 15kg of 20kg of water in a plastic bucket, then add the water without leaking the original solution, and stir with a stick for 1 2 minutes.
5. Pour the prepared water slurry into the bathroom tile. (The water is not leaky, the original solution is colorless and tasteless, and it is exactly the same as tap water).
6. Use a broom to sweep from low to high for more than 10 minutes. The main thing is to let the slurry cover all the bathroom floor, so that the gaps used can seep into the slurry.
7. Leave the bathroom after sweeping for more than 10 minutes and wait for curing. (Curing time is 30-50 minutes, depending on temperature).
8. Clean the ground, clean up from the door with a shovel, mainly to clean up the solidified material that can not penetrate into the tile, (very good cleaning), clean up the excess solidified material, please put it in a garbage bag and put it in the garbage bin.
9. Wash the tiles with water. The whole process takes about 1 hour.
En the aliens.
In fact, it should be the sturdy female doctor who was later said. >>>More
It's the same with my rental house, rats are mainly drilled up in the sewer, that is, in the toilet, you just need to cover the toilet, it's better to press it a little heavier, my house is a big soda bottle with cement on the door with a stick, stuff it, and then there will be no rats.
Sichuan pepper salt
Season salt and pepper. >>>More
The three-bedroom means that there are three bedrooms, and it must be three bedrooms with a hall, and the large hall is also called the second hall, that is, the living room and dining room, in fact, it is also a hall, and the area is divided. It is recommended that you do not only look at the words of the advertisement, but also look at the size of the building area of the house, and whether its housing rate is high? The size of the room and the orientation of the room are also important. >>>More
Of these three pipes, the thickest one should be the drain pipe of the toilet, and the other two, one should be the drain pipe of the washbasin, and the other should be the drain pipe of the floor drain.