How the mirror on the dresser sticks

The dresser and the vanity mirror are disassembled and connected, and we generally use the connecting plate with grub screw connection method.

Clip a connecting plate cutting part into the back panel part of the dresser, make the lower end holes align with the corresponding holes on the back of the dresser respectively, keep it flat and immovable, and then load the grub screws into the connecting plate holes, tighten the grub screws in the clockwise direction with a "ten" shaped screwdriver, and split in the counterclockwise direction.

Install the other connecting plate in the same way as above.

Then stand up the vanity mirror from the plane, place it on the dressing table close to the connecting plate, and gently move it back and forth to make the upper end hole of the connecting plate correspond to the back hole of the vanity mirror one by one, pay attention to maintaining balance, and be careful that the dressing mirror deviates and slips.

Finally, the grub screw is loaded into the upper end hole of the connecting plate, and the grub screw is tightened in the clockwise direction with a zigzag screwdriver, and the grub screw is split in the counterclockwise direction.