-
Anonymous users2024-01-23The adjustment of the valve should not leak, so it can't be broken again in such a short time, but the position may not be too right.
-
Anonymous users2024-01-22The flush valve is broken, change the set.
Open the lid of the water tank, there is a plastic float, just move it with your hands. The float is stuck.
This is a normal phenomenon, basically every toilet is like this, when the toilet is on the water, the leakage to the toilet is to supplement the water in the trap, this water is used to isolate the smell, as long as the water does not leak into the toilet after the end of the water is OK.
Check for yourself whether the water balloon touches the water tank wall and causes water to enter the plug seal, if so, tighten the water balloon, if not, then change the water balloon! It is recommended to find a master to take a look first!
Cause of failure:
1 Problems with the flush switch. >>>More
No, there is a drain pipe in the toilet tank, slightly below the lid of the tank, and if the water is almost full, it will be patted out of the drain.