Why is the telecommunication signal in the same room, and the signal in other rooms is good, but the

Updated on Master bedroom 2024-05-04
5 answers
  1. Anonymous users2024-01-23

    The telecom 4G signal is poor, because the telecom network is not good, and the telecom 2G signal is still acceptable.

  2. Anonymous users2024-01-22

    That's because the walls in the master bedroom are thicker, and the signal can't penetrate them.

  3. Anonymous users2024-01-21

    It shows that the shielding signal in the master bedroom is strong, there are many load-bearing walls, there are reinforced concrete, and the signal is not good! Hope it helps!

  4. Anonymous users2024-01-20

    It's normal for different locations in the same house to have different signal strengths!

  5. Anonymous users2024-01-19

    Mobile communications and environmental geography are closely related. For example, in the same room, the signal strength varies greatly due to the different spatial locations. In a room, in fact, most of the signal propagation is a link established by multiple reflections.

    This multipath reflection of radio waves is closely related to the spatial position of the mobile phone, and sometimes a little wrong distance, the signal will improve a lot.

    There is a signal detection function in the WiFi master key applet, which is very illustrative.

    Mobile phones are one meter away, and sometimes the signal strength varies greatly.

Related questions
Why is it that every time I go to the toilet in a place, the signal 2G is very poor, why, the distan
2 answers2024-05-04

First of all, these are two completely different signals, and secondly, the operator's transmitter does not know how far away, let alone the strength or weakness, and the most unexpected thing is that the toilet is the place of reincarnation of grains, and it is fortunate to have a signal.

Is there nothing else in the kitchen except a scum to change the bedroom?
2 answers2024-05-04

Yes! But how do you change your sewer? There was no kitchen drain in the room!

Why a boy and a girl in an internet café toilet
2 answers2024-05-04

They are doing bad things, and they don't look at them.

Why is the button to flush the toilet one big and one small?
2 answers2024-05-04

The function is to save water, generally use a large button after defecating and a small button after urinating. When the large button is pressed, it generally drains 6 liters, and the small button drains 3 liters.

Why doesn't a button on the toilet press
1 answers2024-05-04

It should be stuck, you open the tank and take a look.

The flush toilet consists of the following main parts: inlet pipe, outlet pipe, seepage pipe, water plug (inlet and outlet), float, drain knob and lever, water refill mechanism, water tank, urinal (the urinal has a bend that connects to the water tank). >>>More