-
Anonymous users2024-01-24It's better not to go, the flue is narrow, and if you take the flue, it will affect the smoke exhaust. Over time, there is a lot of grease and dirt accumulated on the pipe, and there is also a fire hazard.
-
Anonymous users2024-01-23I am a professional water heater installer.
For your situation, it is best not to install, if the pipe is frozen in winter, it will be troublesome, which may lead to a short circuit in the range hood in the corridor.
Now solar energy has balcony wall mounting, and electric water heaters, you can also go to the solar shop to see, give him your old solar energy, pure hand-made...
-
Anonymous users2024-01-22It's not that it can't, it's not suitable and it's not easy to go, the reason is that the friend upstairs has made it very clear.
In order to ensure the purification effect, in the actual design, the exhaust air volume is required to be calculated according to the suction wind speed of the exhaust hood, and the suction air speed of the hood is usually not lower. The minimum exhaust airflow is usually calculated using the following formula: l=2000ph >>>More
It is possible to make a hole above the end of the exterior wall, but this may be negotiated with the property. >>>More
Wanju Technology provides: Installation steps.
1. Trim the reserved hole of the floor slab (the large deviation notifies the civil engineering party to chisel), first pop out the center line of the reserved hole of the floor slab, and trim it according to the size of the reserved hole according to the center line. >>>More
No, this will lead to the phenomenon of smoke stringing in the kitchen fume pipe, and there are requirements for fireproof partition walls, and the fire smoke exhaust shaft is set up separately, and the kitchen fume can not be satisfied.
Wanju Technology provides: installation step 1, trim the reserved hole of the floor slab (large deviation notify the civil engineering party to chisel), first pop up the center line of the reserved hole of the floor slab, and trim it according to the size requirements of the left hole based on the center line. 2. Distribute the pipelines on each layer according to the installation drawing. >>>More