How to connect the wire of this downlight to the switch panel, look at the picture, it has been conn

<> if there is any question before the clan, the annihilation is cleared, and then the royal tong exchange.

Yes, if you don't wiring the whole wiring, you can't distribute it to each downlight, so the decorator did it very right.

If there is space in the wire pipe, you can find a steel wire and use the wire in the wire pipe to wind the steel wire, pull the power cord to bring the steel wire in, and wrap the power cord to be threaded on the steel wire, (pull out one and pass it into 3 or four) Pull the wire to wear it, try it.

The spotlights in the ceiling of the living room are based on how many spotlights you want to place, and a light switch controls several spotlights at the same time. Therefore, the spotlights and the living room lighting, the power zero line are connected together, directly connected to the power box zero line row, and then control several spotlights according to each switch, connect the power control lines of these spotlights together, put a few spotlight control lines in a few groups, and lead them to the switch box together with the living room lighting, and add the lighting control line according to the number of control spotlight groups, and install the light switch. The thread end is generally left at 20 cm.

OK. Disassemble the existing switch, change the original series line, and then replace the original single-open switch with a double-open switch.