What happens when the end of the lathe is offset from the twisted hole

If you want to deviate from the axis of the taper, the deviation can not be large, the length of the workpiece is different, the length of the workpiece can be large, the short point can be small, except for the degree of a few degrees The accuracy is not high, you can use this method, and the general taper processing should not be used. Mainly for the long axis degree of small small carriage travel stroke is not enough, and there is no large carriage walking and small carriage walking at the same time device of the turning mechanism, deviation lathe has a scale, the amount of deviation of processing, according to the length of the workpiece, the size of the degree is decided, the excessive chuck clamp and the top damage is large,

There is a corresponding screw on each side of the bottom side of the tailstock. >>>More

Hello! Lathe tailstock.

Lathe tailstock >>>More

The manual feed of the tailstock is changed to a motor plus reducer drive, and the motor drives the reducer to transmit the power to the top feed screw through the clutch to achieve feed. When an automatic feed is not required, the clutch is disconnected and the operator can turn the lead screw by the handwheel to achieve the center feed.

The center height and latitude concentricity of this lathe have errors in order to correct the tailstock deviation after adjustment.