-
Anonymous users2024-01-24In addition to gas, battery, and water pressure, a gas water heater also has an indicator, which is the minimum starting water flow.
The basin faucet does not start, and the water flow of the faucet should be less than the minimum.
Please check whether the faucet outlet filter is blocked, remove it and clean it; Or, is it connected in parallel with other water supply circuits, such as the reserved small kitchen treasure circuit, if there is, close the valve.
-
Anonymous users2024-01-23Long pipeline; The high faucets are all causes. You can compare the pressure in the kitchen and the toilet, and be sure that the pressure in the toilet is less.
-
Anonymous users2024-01-22See if the hot water valve is open, either turn off the cold water valve in the bathroom cabinet, open the hot water valve lightly, and then open it again, there must be a delay.
-
Anonymous users2024-01-21There are two possibilities, one is that the hot water pipe is not connected, and the other is that the hot water pipe is connected, and the angle valve under the faucet is not opened.
-
Anonymous users2024-01-20The water heater is connected to the toilet and bathroom cabinet on the switch is broken.
-
Anonymous users2024-01-19Gas water heaters require gas, batteries, water pressure, and water flow.
Check whether the faucet outlet filter is blocked; Is it connected to other water supply circuits in parallel?
-
Anonymous users2024-01-18How does this faucet compare to a kitchen shower?
In addition to gas water heaters, are there electric water heaters and small kitchen treasures?
Use a sturdy rope that is a little thicker, tie a knot at intervals on the top, wash it down with water, and repeat it several times.
It is estimated that it is caused by the large change in the diameter of the front and rear pipes, the thickness of the front section and the thin back section, and the high pressure of the water.
There was hot water in the sink before, but recently it suddenly ran out, and it is possible that the valve core is broken.
Or the quality of the anti-odor floor drain is not good, or it is not installed well.
Open ten holes, switch to control the light.
The live wire is connected to all L posts, the neutral wire is connected to the N binding posts of the two sockets, and the ground wire is connected to the E (there is a vertical and horizontal symbol in the circle) binding posts of the two sockets. The L1 binding post of the switch is connected to the positive pole of the lamp, and the terminal N terminal of the socket is connected to the negative pole of the lamp. >>>More