At home, the living room light is automatically turned off, and then the living room is out of power

Updated on Living room 2024-05-25
1 answers
  1. Anonymous users2024-01-24

    If the circuit has a virtual connection, carefully check the line, find the virtual connection, and reconnect it. Otherwise, it is easy to burn electrical appliances, and after a long time, the virtual connection will accelerate oxidation and heat up due to ignition, and the consequences are unimaginable.

Related questions
The sudden turn off of the living room light was a sign of something
3 answers2024-05-25

It could be that your light bulb is broken, or that your switch is turned off, and it doesn't indicate anything.

The LED light in the living room at home will automatically flash and change the light at the beginn
1 answers2024-05-25

If it's the kind of small plate of lights, go directly to change a plate of light strips, and you can find a master to see if it's complicated

The light in the living room of the house suddenly flashed, and then the three sockets and the balco
4 answers2024-05-25

During construction, the power supply distributed everywhere is divided into open lines, your balcony and the bedroom is a power supply, this power supply depends on your situation is to lead to the power cord there is a virtual connection or the wiring is not tightened, or the air switch of this road may be damaged, long-term this will burn out the line, the damage to the refrigerator and air conditioning is also very large, very serious, deal with it quickly.

The LED light strip in the living room at home is old and bad, and the other places are fine, what i
2 answers2024-05-25

Maybe the ballast is broken, replace it with a new one!

There are four lights in the house, the living room lights are turned on, the others are not powered
1 answers2024-05-25

The living room light switch may be a dual-control switch, L, L1, the center end of the switch) is connected to the live wire, and L1 is the living room light. This phenomenon occurs if L2 is connected to another lamp control cable. It should be another control line, connect it to L, and it will be correct.