What causes infrequent water seepage above restroom risers?

Updated on Bathroom 2024-05-02
3 answers
  1. Anonymous users2024-01-23

    It should be that the waterproofing upstairs is not done thoroughly, the only solution is to do the work from above, the following is not good, generally there are gaps in the pipe wall and pouring layer, and the upstairs waterproofing is not caused by the position of the pipe wall with waterproof materials, you can use quick-setting cement to go upstairs to water around the pipe wall, it should be better.

  2. Anonymous users2024-01-22

    It may be that the caisson of the upstairs bathroom is waterlogged, so the only way to solve the problem is to open the caisson of the upstairs bathroom and reapply the drainage system. If it doesn't work, you can only buy plugging king or waterproofing agent to plug from the bottom, but this cannot guarantee the effect.

  3. Anonymous users2024-01-21

    Often, it is possible that the waterproof layer is not in place or there is no sticky hole! It is recommended to use a plugging spirit to hook all the brick joints.

Related questions
17 answers2024-05-02

1. Water seepage on the wall caused by pipeline leakage. Water seepage on the wall caused by leaking pipes is a relatively common cause. You can look at the construction drawings and check the direction of the water pipes at home. >>>More

5 answers2024-05-02

1. Water pipe leakage: When laying water pipes in the bathroom, the water pipe interface is not tightly connected, and the water pipe leakage will also lead to water seepage on the exterior wall during use; 2. The waterproof layer is not done: secondly, the waterproof layer is not done well, which will also lead to water seepage on the exterior wall; 3. Improper dry paving of Xinxiang tiles: >>>More

8 answers2024-05-02

I have an experience to share, because there was a situation at home, the bathroom floor was not seeping downward, but seeping upward, at that time my father was also worried because of this problem, but it was finally solved, here are our solution steps: >>>More

5 answers2024-05-02

When you decorate, you must not do a good job of waterproofing, generally to use plugging king, waterproof glue, it is best to use asphalt to fill the entire bathroom floor to the wall 40 cm high all covered with asphalt, especially around the sewer pipe, to fully cover, can not leave empty corners and cut corners, so that not only waterproof but also moisture-proof.

2 answers2024-05-02

If you haven't renovated yet, then don't worry, see whose house is leaking when it comes to the bathroom. Joked. It is recommended to close the main valve and drain the water, see if the water seepage, it is best to test the pressure to accurately judge, and it is the same for each family.