-
Anonymous users2024-01-24Remove the battery, open the shell, clean it with anhydrous ethanol or high liquor, wipe it dry to ensure that there is no moisture and assemble it on the line, do not use a hair dryer to dry, high temperature will melt the solder joints on the circuit board to form a broken circuit, (it is not visible to the naked eye) at the same time to wipe the conductive rubber under the key, if there is an insensitive situation, you can put the corresponding position of the front button of the circuit board, smear it with a pencil, and increase the conductivity effect.
Check and replace the battery of the remote control, if there is no problem with the remote control, it is the failure of the roof remote control receiving device or mechanical parts, contact the manufacturer for on-site repair.
Start by pouring a basin of hot water (the hotter the better) into the toilet and scalding the soap to soften. Then use an electric snakeskin tube to unclog the plumbing tool, and the soap is wrenched. After that, pour a basin of hot water into the toilet. >>>More
The solution to the mobile phone falling into the toilet: see if it is completely immersed in the yellow soup of the toilet, if not, quickly pick it up, don't mind picking it up directly with your hands, if you feel dirty, wrap your hands with a plastic bag or paper towel to pick it up. If it is completely immersed in the yellow soup, then put on a disposable glove or plastic bag and put it on your hand, and then go and scoop it up. >>>More
Either pick it up, wash it and continue to use it.
Either don't pick it up and replace it with a new one. >>>More
Use a gong-shaped steel wire that is used to dredge sewers. The button goes in, it feels touched, and it pulls out hard. Generally, there is a sink in the toilet, which will not fall directly into the sewage pipe, so it is easy to block.