How to remove grease after a long time of use in the kitchen?

When the wood in the kitchen is full of grease, you can use bleach powder and water to paint the surface of the grease, and rinse it with water the next day. You can also add some vinegar to the water to wipe the wood furniture, the latter is suitable for oil stains.

Less woodwork. When there is dirt accumulation in the aluminum pot and pan, you can use the squid fish bone to wipe it lightly, and it will be as smooth as new.

The old dirt of enamel ware can be wiped with a brush dipped in a little toothpaste, and the effect is very good.

The electroplating faucet will turn black and lose its luster over time, and it is not ideal to wipe it with soap and detergent, the best way is to put a little flour on a dry cloth, wipe the faucet repeatedly, and then use it wet.

Wipe with a cloth, and finally wipe again with a dry cloth, and the faucet will be as bright as new.

If the kitchen knife is rusty, you can scrub it with potato chips or radish slices dipped in a little fine sand, and the rust can be removed.

If you have grease on the surface of the gas stove, you can apply the hot soup left over after boiling the noodles on the surface, wipe it with a cloth after a while, and then rinse it with water.

The grease on the kitchen floor can be wiped with a little vinegar on the mop, and the effect is better. The kitchen is the most likely place in the room to hide dirt, and most of it is oily, so it is more difficult to clean.

Some decontamination methods for different kitchen utensils can be tried.

When the wood in the kitchen is full of grease, you can use bleach powder and water to paint the surface of the grease, and rinse it with water the next day. You can also add some vinegar to the water to wipe the wood furniture, the latter is suitable for oil stains.

Less woodwork. When there is dirt accumulation in the aluminum pot and pan, you can use the squid fish bone to wipe it lightly, and it will be as smooth as new.

The old dirt of enamel ware can be wiped with a brush dipped in a little toothpaste, and the effect is very good.

The electroplating faucet will turn black and lose its luster over time, and it is not ideal to wipe it with soap and detergent, the best way is to put a little flour on a dry cloth, wipe the faucet repeatedly, and then use it wet.

Wipe with a cloth, and finally wipe again with a dry cloth, and the faucet will be as bright as new.

Wipe it with dish soap or other chemical solvents to remove stains, and there is no way to be lazy.