-
Anonymous users2024-01-24The two large holes in the toilet chassis are the optional drainage hole spacing for toilet installation, which are 300mm and 400mm respectively, and the toilet only needs one suitable one, and the other must be sealed, otherwise it will cause water leakage.
-
Anonymous users2024-01-23Answer: One is a sewage hole, and the other is a reserved sewage hole. There are two main types of toilet pit spacing in the bathroom: 30 cm or 40 cm, and the manufacturer reserves two sewage outlets at the bottom of the toilet according to these two pit spacing. The installer can use one of the sewage holes according to the actual situation of the toilet and block the other sewage hole, which effectively avoids the situation that the owner chooses the wrong toilet pit distance and the toilet cannot be installed or has a gap in the installation.
The small one inside is the siphon, which enhances the suction of the water.
-
Anonymous users2024-01-22Siphon to enhance the suction of the water.
The sofa factory generally uses non-woven fabrics. However, it is easy to weathered and cracked for a long time, so it is recommended to buy thin cotton cloth, the cheapest one, and the key is to breathe. The bottom is not touched and used, and it will not be broken when discarded on the sofa.
Because it wasn't water, it was cement, and it froze when it came into contact with him.
Toilet drain leak Bar toilet bottom clean Seal with glass glue for 48 hours in use.
Because of the bottom of the toilet, the drain pipe is curved. A part of the water is stored in the location of this bay. Its function is to stop the smell of the sewer from being reversed. >>>More
If the floor tiles are paved and only the sewage pipe mouth is left, the bottom of the toilet can be fixed with glass glue or white latex, and then put the toilet bowl on the bottom of the toilet bowl with glue and wait until the glue is dry.