-
Anonymous users2024-01-23Do not turn on the machine until the water has dried. No problem. Use a hair dryer to blow more. Just let it dry for a while. We're in the same situation. Hehe.
-
Anonymous users2024-01-22Ostensibly it is dry.
You still have to use a hair dryer to blow down more.
If you don't, take it to a sunny place.
After a while, try to turn it on, if it doesn't turn on, continue.
I really can't open it and send it directly to the hospital.
-
Anonymous users2024-01-21Sun, you can also use a hair dryer to blow it, completely dry and then install the battery to turn it on, congratulations on normal, if it doesn't work, send it for repair.
-
Anonymous users2024-01-20Be sure to remember not to turn it on, if there is a high-power lamp, you can shine a light, in short, after the water dries, good luck, continue to use.
-
Anonymous users2024-01-19Not bad. After drying, I will hand it over to the after-sales service.
-
Anonymous users2024-01-18Do not turn on the machine and take it for repair.
-
Anonymous users2024-01-17Did you pick it up?
Let's throw it in.
-
Anonymous users2024-01-16Hurry up to customer service or repairer, according to my experience, it may be that the machine is in series, don't start the experiment casually, it may burn the machine, don't try to be cheap for a while, and in the end it is you who are sad, and the repair cost is up to fifty.
-
Anonymous users2024-01-151 Go to after-sales.
2 If you buy it at a major sales location, you can repair it there.
3 Throw it down again, and wash it away with water.
-
Anonymous users2024-01-14Go fix your phone and let him see if it's in the water.
If the mobile phone falls into the toilet, remove the electrical board as soon as possible to avoid the mobile phone from burning out. >>>More
This is a little troublesome, the full name of the resistance screen is the resistance touch screen, the resistance screen is a sensor, it converts the physical position of the touch point (X, Y) in the rectangular area into a voltage representing the X coordinates and Y coordinates, the coordinates inside the water are messy, the slight click is not accurate, and the serious direct is paralyzed, in short, this thing is not easy to repair, even if it can be repaired, it can not be restored to the original state, if you want to change it, change a screen handle, about 80 100 or so, good 120 or more, See how long your phone has been used! It's been too long and there is no repair value (mobile phone Internet access, continue to ask can not continue to reply to the question, please understand).
Blow dry or rush to the after-sales service.
If there is liquid inside the mobile phone, it is recommended that you do not use the mobile phone at first, take the mobile phone to the local after-sales service center for testing and processing as soon as possible, and enter the vivo official website - service - service outlets to check the nearest after-sales address and contact number.
It's no problem to turn on the phone, but the performance is not good, it is absolutely necessary to repair it, you can't deal with it yourself, you must have professional tools, the phone is flooded, it is not said that it is dried on the line, the performance is absolutely damaged, it is recommended to repair it in time Unless you buy a waterproof mobile phone, it will be fine.