-
Anonymous users2024-01-23It is recommended that you use an electric drill to drill the hole and fix it with screws, so that it is stable and improves heat dissipation.
-
Anonymous users2024-01-22When the temperature is high, the adhesive paste is unstable.
-
Anonymous users2024-01-21You turned out to be attracted by a magnet, it is recommended to use an electric drill to open a small eye and put on the screws, which is not only stable, but also the light board is also conducive to heat dissipation, and the light piece is used longer.
Traditional fluorescent tube ceiling lamps are not of much value to be converted into LED ceiling lights, their internal circuitry such as drivers and ballasts are not compatible, the light source is not the same, and the mask that emits the light is also different. And at present, LED ceiling lamps are already very cheap, and it is not recommended to retrofit.
The matching LED lamp cannot be replaced, because the LED lamp is not a tube, and the overall one can be replaced. Changing the lamp tube should be connected to the lamp holder at the same time, but I personally think that the lamp is not good-looking.
There is really a little skill in the selection of the wattage of the kitchen LED lamp, too bright is a bit of a waste of electricity, too dark and inconvenient to operate, so the choice must be very critical. The power of the LED lamps is calculated individually for each lamp bead. It depends on how many lamps you buy. >>>More
You can look at the light causes.
Hello, if you use the LED lamp with the integrated ceiling, you can't replace the lamp, because the LED lamp is not a tube, you can change the overall one.