Is the bathroom shower valve inlet divided around?

The water inlet is the part where the inner and outer wires are butted, and there is a rubber washer inside, which can be tightened to see. If it still drips, the gasket or connector is damaged.

45-60cm above the ground, it is best not to exceed 60, otherwise many bathroom cabinet basins are not easy to install.

In fact, in your first picture, there is a water pipe connection behind the toilet. >>>More

First, according to the installation height of the ceramic urinal, determine the height of the urine sensor, and avoid installing too high or too low, (the length of the small water pipe of the urinal is not enough, and it affects the use of some people); The height of the ceramic urinal from the ground is about 950mm, and then the appropriate urine induction size is determined according to the ceramic and internal plumbing; Before installing the urine sensor, it should be noted that the sediment and impurities in the pipeline should be rinsed with a certain amount of water to prevent impurities from entering the solenoid valve, the depth of the pre-embedded box according to the size of the embedded box and the completion of the wall, the tile surface should be flush with the construction protective cover, and the wall with a thickness of less than 8cm should be selected with a height of 6cm or directly using the surface-mounted urine sensor and type. >>>More

This water and water reservation problem, should be determined first to determine the bathtub and then to study, the general bathtub manufacturer will give a size drawing of the installation reservation, according to the drawing.