-
Anonymous users2024-01-24There is a float in each automatic flushing toilet, as the water level in the toilet rises, the buoyancy generated by the float is getting bigger and bigger, when the water level rises to a predetermined value, the buoyancy generated by the float will be transmitted to the switch through a seesaw structure, the switch is closed and then the water inlet valve will not enter the water, when the water is released, the button or wrench pulls the plug of the water discharge, and the plug is automatically pulled out. After the water is discharged, the plug automatically returns to its position under the action of the spring and enters the next round of water filling cycle.
The float switch in the toilet is actually designed according to the principle of lever, you just need to twist the small screw of the top switch on the other end of the float in a clockwise direction a few times to adjust it to the position you need to fit. If it's a pole type, you press and hold the float adjustment button and press it down directly to adjust it to the position you need to fit. >>>More
I don't know if you want to lower the water level in the toilet pit or lower the water level in the tank? >>>More
There are adjusting parts in the tank, and the F-cross screwing knife should be prepared.
Dear,This is the solution that Xiaomi has sorted out for you,Because it can't be copied,So Xiaomi can only help you take a screenshot,I hope it can help you。
There are screws in the water tank on the water, and there is an iron that pinched the iron in the middle of the iron and pulled the iron upwards to adjust the low, down is high, open the upper lid of the toilet, you can see the ball linkage mechanism inside. >>>More