-
Hello! There are two ways to connect a router to another router:
1) "Superior-Superior" Relationship - Ensure that the first three sets of IP addresses of the LAN ports of the two routers are different, for example, if the higher-level router is, then the lower-level router can be;
Then connect a network cable from the LAN port of the "upper" router to the WAN port of the lower-level router, and confirm that the lower-level router uses the "dynamic IP (sometimes called DHCP)" mode to access the Internet.
2) "Same level" relationship method - ensure that the first three groups of IP addresses of the LAN ports of the two routers are the same, and the last group is not the same, for example, one is, then the other can be, and then connect to any LAN port of the two routers of the same level with a network cable, and must strictly confirm that the newly added router of the same level should turn off the DHCP function.
-
Change the IP of the second one, and connect the line to the output of the second one.
-
If you're a router bridge, you need to configure it exactly right, and it supports bridging. If it's not a heads-up line to the living room, log in with your phone and check the settings, sent and accepted packets, if the latter is 0, you are not connected to the Internet. Please check the check settings again.
-
Unplug it, restart it, or refresh your settings.
-
How are your two routers connected???
Just buy a repeater, use the wireless relay signal over, this device is quite convenient to use, where you have a bad signal at home, just plug this in. The WIFI range of this wireless router can be moved casually. >>>More
It is possible to be rubbed by the network, and it is also possible to be robbed of the network speed by other devices, so set up a broadband control to limit the network speed of each machine.
Connect your computer to the router you want to modify with a network cable, then enter the run command CMD, enter arp -a in the DOS window and press enter, check the IP address of that router. Then it's time to set it up.
The first IP is set, the second is set, the second router turns off DHCP, after the WDS is turned on in the wireless interface, the SSID of the first one is the name of the first server, and the password test and password must be the same as the first router, and the first computer should also be set up in the same way, but there is no need to enter the password.
Just set it up according to the wireless bridging method. >>>More