After the geothermal installation is completed, what is the standard for the hemp floor? Bathroom an

Updated on Bathroom 2024-05-12
2 answers
  1. Anonymous users2024-01-23

    The landlord is really an attentive person. The floor of the kitchen and bathroom should be a hemp surface, because it has to be tiled on it, and if it is smooth, the adhesion is relatively poor. Ash and stone are more scattered, and two possibilities are estimated:

    Every time the ratio of cement and yellow sand is adjusted, there is more sand, generally 3:1, and it is possible that after the ground is done, you should pour some water the next day to maintain the floor. Generally speaking, the floor level is also good for hemp surface, because when the geothermal heat is just working, there will be a layer of water vapor between the ground and the floor, if the surface is smooth, the water vapor is difficult to volatilize, and the hemp surface, the water vapor will be in the small hole, and when it reaches a certain temperature, the water vapor will evaporate quickly.

  2. Anonymous users2024-01-22

    Well, the problem is not big, that situation can only be said to be that the construction workers are too sloppy, now only before doing waterproofing, the bathroom floor and then take the cement mortar, thin from the touch, if you do waterproofing directly, it is not ideal!

Related questions
2 answers2024-05-12

The wood is not dried and the floor is processed, and in this case, you can get compensation by looking for the local 12315.

2 answers2024-05-12

Is there a sound when a person walks on it, lies on the floor to see if the floor is flat, taps it gently with his hand, and the sound is crisp.

2 answers2024-05-12

This is not clear about your problem, after the air conditioning is installed, it is generally necessary to follow the carpentry into the field, first of all, the carpenter enters the line is not threaded, if there is no threading is easier to change, if the threading is, then it is troublesome, the previous group of lines is recommended not to redo a group of lines, because the line may not be long enough after changing the door, so that the wiring is not ideal for home improvement, and the later disadvantages are big.

1 answers2024-05-12

If you are in the same place, you can press it back, but you can lose some of it, you need to make sure that the floor is still sold. Or you can install the floor according to the number when you restore it, but then the labor cost will be more than doubled.

5 answers2024-05-12

Inverter air conditioning has become the mainstream, with higher comfort and better energy saving. >>>More