-
Anonymous users2024-01-24Before changing the firing pin, you need to cut off the air supply of the air nail gun. Generally, the air nail gun needs to remove the 4 screws on the back cover first, and then remove the iron top cover and the upper aluminum top cover, and then you can see the swimming valve in the cylinder.
Using a large floor renovation machine, the paint layer, surface layer, and wood layer are removed several times by about millimeters. >>>More
In order to maintain the original plank structure (the blocks are interlocking), it is necessary to open all the sides and lay them again. If you don't need that, you can cut off the damaged piece separately, then remove the edge of the new floor, put it in directly, and glue it with structural adhesive.
First of all, the circuit pipe can not be laid, and the hydropower transformation can only be changed at the break point, if you want to change it all, all the top surface of the pipeline is laid, and you need to do gypsum board ceiling, which is expensive. >>>More
Take care of hardwood floors.
1. The humidity in the room should not be too large, keep the floor dry and clean, and wipe it with a wrung out cotton mop for daily cleaning; In case of stubborn stains, wipe with a neutral cleaning solvent and then wipe with a wrung out cotton mop, and never use acid, alkaline solvent or organic solvents such as gasoline to scrub. >>>More
You can't mop it with open water, you must go to the water of the dry mop, and it's best to check it yourself with a towel.