Can you wash the toilet directly with sulfuric acid?

Do not use concentrated sulfuric acid to clean the toilet. Concentrated sulfuric acid can be diluted into 30% dilute sulfuric acid and then cleaned, which is very clean and safer.

If you accidentally splash on your skin, rinse it off with water right away and you'll be fine.

Concentrated sulfuric acid cannot be used directly, because concentrated sulfuric acid will damage the enamel layer of the toilet bowl and corrode the sewer pipe.

Note: When diluting concentrated sulfuric acid, slowly pour concentrated sulfuric acid into the water along the wall of the glass, do not pour the water into the concentrated sulfuric acid, otherwise a large amount of heat energy will be generated, and the water poured into the concentrated sulfuric acid will quickly become water vapor, and the water vapor will splash out when it breaks, which is easy to hurt people.

When concentrated sulfuric acid is poured directly into the toilet water, it will release a lot of heat, which may splash out, which is more dangerous. It is not advisable to use chemical methods to unclog toilets and pipes. If you want to use it, hydrochloric acid is suitable.

No, this will burn the surface of the toilet tiles, you can wash it with pasteurizer!

Hello, about your question, I think that the concentrated sulfuric acid is diluted into 30% dilute sulfuric acid and then cleaned, so that the cleaning is very clean and safer. If you accidentally splash on your skin, rinse it off with water right away and you'll be fine. Concentrated sulfuric acid cannot be used directly, and concentrated sulfuric acid is harmful to the toilet enamel layer.

I don't know if it can be washed clean, but I can tell you that this is quite a dangerous thing, concentrated sulfuric acid is strongly corrosive, and when dissolved in water, it releases a lot of heat, which is easy to make the water boil and cause concentrated sulfuric acid to splash on the skin and clothing, resulting in serious consequences. So it's recommended that you still don't try it.

Hope it helps.

If there is too much dirt, you can use grass pickling, pay attention to safety.

Summary. Kiss, never use sulfuric acid to wash the toilet. Even if the dirt is removed, the toilet bowl is still corroded.

And there is danger in the operation, the concentration is not easy to control, it is not easy to make it low, it is easy to hurt people if it is high, and the drain pipe cannot withstand corrosion, can you directly wash the toilet with sulfuric acid?

Dear, you must not use sulfuric acid residual silver to wash the toilet bowl. Even if the dirt is removed, the toilet bowl is still corroded. And there is danger in the operation, the concentration is not easy to control, the low buried fiber is not good, the high is easy to hurt, the drainage pipe can not withstand corrosion, the harm of sulfuric acid sulfuric acid can cause strong irritation and corrosive effect on the skin and mucous membranes, in addition, it is mainly more susceptible to damage to the respiratory tract and the skin of the eyes and hands, sulfuric acid can also be inhaled poisoning, inhalation of sulfuric acid mist can cause respiratory tract irritation symptoms, after the silver year mistakenly ingested the sulfuric acid, the mouth, pharynx, behind the sternum and abdomen, will immediately produce severe burning pain if, Frequent contact with sulfuric acid but as long as there is no direct contact with the skin, sulfuric acid usually does not volatilize the main point is to hurt the skin, you should do protective measures when working, eat more alkaline foods and fruits, this state is recommended not to touch these things for a long time.

Wearing a damp mask can greatly reduce the harm. But wash frequently.

It is not possible to use sulfuric acid to wash the toilet. Even if the dirt is removed, the toilet bowl is rotten. And there is danger in the operation, it is easy to hurt people, the concentration is not easy to control, it is difficult to make it low, it is easy to hurt people when it is high, and the drainage pipe cannot withstand corrosion.

Here are three steps to wash the toilet:

1. Prepare a handful of baking soda.

2. Wet the inner wall of the toilet bowl and sprinkle it evenly on the yellow stains of the toilet.

3. Let the baking soda sit on the yellow stain for more than 10 minutes, then rinse it, and if it is not clean once, just do it again.

The toilet bowl has been used for a long time because of the S bend, and the scale inside the S bend is very difficult to wash, and the scale of the toilet bowl is in the upper part, and it is difficult to flush with sulfuric acid alone. It is difficult to be effective by punching alone.

So I suggest you still don't try it, it's also in vain. The smell of the toilet bowl is partly due to the fact that the porcelain absorbs the odor. , you will understand when you look at the tank.

Let's use hydrochloric acid.

It is not safe to use concentrated sulfuric acid.

Hydrochloric acid also has some taste, but it is gone after a few brews, and it is safe and easy to buy.

It is best not to use it, it is recommended to use a professional slightly acidic cleaning agent, if not, you can try it with vinegar!!

Yes, sulfuric acid can dissolve the insoluble alkali and salt in the toilet bowl to achieve the purpose of cleaning, but pay attention to safety.

Sulphuric acid? No, you can't.

Hydrochloric acid, very good.

Sulfuric acid is a strong acid that can be used to clean and unclog toilets, but it needs to be used with caution and follow these precautions:

Safety protection: Before using sulfuric acid, be sure to wear appropriate protective gloves, goggles, and protective clothing to avoid direct contact with skin, eyes, etc.

Good ventilation: Ensure that the environment where sulfuric acid is used is well ventilated and avoid inhaling harmful gases.

Dilution use: Sulfuric acid should be diluted according to the instructions for use, and it is generally recommended to mix sulfuric acid with water in a ratio of 1:10. Pour the sulphuric acid into the water slowly, rather than into the sulphuric acid, to avoid spills and dangerous reactions.

Handle with care: When using sulfuric acid, be careful to avoid splashing it on other objects or the ground, which can cause corrosion and damage.

Avoid mixing with other cleaning agents: Do not mix sulfuric acid with other cleaning agents, as it may cause harmful chemical reactions and release toxic gases.

Whether you can or not, it's better not to use it.

Sulfuric acid is a dangerous chemical, and high concentration of sulfuric acid is extremely corrosive, and it will even be seen to "smoke" and volatilize, which is extremely irritating and corrodes the skin. That is to say, washing sulfuric acid also has a corrosive effect, and it will hurt the skin if it is not operated well.

In addition, although the toilet bowl is a ceramic product, acid will not corrode, but as long as the toilet has cracks, acid will penetrate into it, making the gap larger, and sulfuric acid flowing into the pipe will also corrode the cast iron pipe and corrode the cement.

In addition, it is emphasized that sulfuric acid is a state-controlled product, and the purchase of sulfuric acid must be filed with the public security department. No matter where your sulfuric acid comes from, if something happens, or someone reports it, someone will come to your door to trouble you. Remember. Wish.

No, you can't. Sulfuric acid is highly corrosive, and the dilution of concentrated sulfuric acid will release a large amount of heat, which is easy to sputter and hurt people. In general, it is much safer to use hydrochloric acid to wash toilets.

Concentrated sulfuric acid is highly corrosive and may have a certain corrosive effect on toilets and pipes. When concentrated sulfuric acid is poured into water, it will release a large amount of heat, which may splash out, which is more dangerous. It is advisable not to use chemical methods to unclog toilets and pipes.

If you want to use it, it is also best to use hydrochloric acid. Second, if something blocks the pipe of the toilet bowl (such as rags, sundries, etc.), pouring concentrated sulfuric acid has no effect at all. To sum up, if the toilet is clogged, you must think calmly, if it is greasy and clogged, you can try hydrochloric acid, do not use sulfuric acid.

If a hard object falls into the toilet and causes the toilet to clog, you can think of a way to flush it with a large amount of water first, or use physical methods such as iron hooks and manual pipe dredging devices to dredge it.

No, one is that sulfuric acid is a dangerous product that can be easily made into drugs, and you can't take it out privately, which is illegal. The second is that strong acid cannot be discharged through the sewage pipe, and if you wash it, it will flow into the sewage pipe, which is also illegal. So it is recommended not to use it.

Definitely not. Because the main ingredient of the toilet bowl is also ceramic. Ceramics are the main components of calcium carbonate.

So sodium sulfate is a strong acid, and what about the toilet cleaner used in the market? It is an acidic solution. Diluted sulfuric acid, dilute sulfuric acid, or dilute hydrochloric acid.

He can and. The component of the toilet bowl, calcium carbonate, undergoes a chemical reaction to corrode it, so it is not possible to clean the toilet bowl directly with sulfuric acid, and it is necessary to dilute it to a certain proportion. before you can use the washer, the toilet.

It's safe and clean.

No, one is unsafe, and the other is that sulfuric acid will corrode the porcelain of the toilet bowl and make the toilet more likely to get dirty. If the toilet bowl is really difficult to handle, you can dilute the acid to a lower concentration before using it.

You can't use sulfuric acid to wash the toilet directly, and this is very corrosive, so you can't use it, you can buy some special products for washing toilets online.

Never use sulfuric acid to wash the toilet. Even if the dirt is removed, the toilet bowl will be corroded and unusable, and it will be broken when used. The reason is that things like hair, no, sulfuric acid can corrode pipes.

Can you wash the toilet directly with sulfuric acid? It is best not to use sulfuric acid to wash the toilet directly, it will damage the toilet bowl and you may also get hurt. There is a professional cleaner for washing the toilet, never use sulfuric acid.

No, the toilet bowl will corrode, and if you accidentally come into direct contact, it will also corrode.