Put a pot of green plants on top of the vertical air conditioner in the living room, and after a lon

First of all, clean the air conditioner filter, then wipe the inside of the air conditioner with a rag, set it to the ventilation gear first, and let the air conditioner remove the odor in the machine before heating.

When the air conditioner is not in use during the season, it is best to clean the filter and ventilate it for half an hour, so that when it is turned on again, there will be no peculiar smell. Usually clean the filter often, take out the filter and rinse it on tap water.

Is there a reason for not watering? Or is it caused by turning on the cooling and heating, and the plant is close to the air outlet for a long time?

You're talking about heating, because the air from the air conditioner is very dry, and the hot air evaporates all the water of the plants, so the plants will turn yellow and the plants will dry up and die.

First of all: 1. You didn't take good care of the family and raised her to death (no watering, wood gets sunshine, etc.); Secondly, professional analysis 1: the air outlet above the vertical air conditioner, if the air volume is large, if the angle is not good, for a long time, the plant leaves have been blown, and it is so cold, one is open and one is closed, one is cold and one is hot, resulting in; 2. There is a filter screen at the air outlet, and if it is not cleaned for a long time, there will be a lot of bacteria, which is also one of the reasons for the air conditioning disease; 3：

Household air conditioners are all dry winds, and if you don't water them, you're dying fast. Well, that's all. If you're dead, you're dead, don't be too careless O( O haha

Because the wind of the air conditioner will blow upwards, it will blow after a long time.

Moreover, the air conditioner will take water, and if the water of the plant is absorbed, it will naturally die.

After determining the position of the internal and external machine, immediately install the internal machine hanging plate, and after the external machine and the internal machine hanging plate are firmly installed, then straighten the connecting pipe to check whether the pipeline is bent and deflated; Next, check the flare at both ends, if there is a crack, it should be re-flared, otherwise fluorine will leak. Finally, check the control line, and after making sure that the pipeline, control line, and outlet pipe are in good condition, tie them together and seal the connecting nozzle. When crossing the wall, two people should cooperate inside and outside the wall to slowly penetrate out to avoid strain; Connect the pipeline with the internal and external units, and connect the control line.