-
There are errors, and the resistance value measured with a multimeter is not accurate at all, only a rough measurement, as long as the measurement is not broken, it is good!
If you want to measure accurately, you need to use a bridge!
-
You didn't choose the right gear.
-
Which resistance gear are you using?
-
I don't know how you measured it.
-
Use the minimum gear of the ohmic file to measure the resistance value.
There is a short circuit between the two lines.
The two wires can be used as one, and the ground wire can be used as the zero line temporarily. >>>More
There is no problem at all, the smart toilet 220-250 can be used.
The low line voltage in the kitchen is due to other loads being skewed into the wiring. If the contact is corroded, it becomes a resistor invisibly. The grid voltage passes through this resistance to form a certain voltage drop. >>>More
Check the voltage of the live wire to the neutral line and the voltage of the live wire to the ground wire. >>>More
Determine that it is a circuit, not a light is not a switch, it is recommended to see if the light is broken or a switch problem, and try to change a switch or something.