-
Anonymous users2024-01-24Because the water in the toilet runs out and the water starts to enter, at this time, the faucet is diverted, so the amount of water becomes smaller, and it will not be after a while. This also means that the pressure of your water is not high enough, or the pipes are too thin.
-
Anonymous users2024-01-23If it occurs at the beginning of installation, it means that the pipe used is too thin, or there is a blockage at the joint.
There is also whether the water pipe is clogged with dirt and the water pressure is low.
Bathroom faucets should often use warm and hot water, which is easy to produce scale, resulting in a small water output of the faucet, you can unscrew the faucet spout and clean it to wash off the small scale.
Booster or self-priming pumps?
My home is in the suburbs, there is a water tower in the village, regular water supply, that is to say, there is water when the water is opened at home when the water is regularly fed, and there is no water when the faucet is not opened, the house is on the second floor, and there is a water storage tank on the roof of the building that supplies solar energy and water to the flushing toilet, and the solar energy and supporting cold water buckets and water storage barrels are connected to the water supply pipelines in the village through pipelines, and there are water stop valves to prevent backflow. Due to the lack of water pressure when the water is supplied regularly, the solar energy and the cool water bucket and the water storage bucket are not on the water, and now they are filled with a self-priming pump with a hose from the outside, I want to install a pump on the main pipe of the village pipe into my house, so that when there is water, the water is pumped up through the pump, is it a booster pump or a self-priming pump? If you use a booster pump, I think it can only work when the water supply is supplied in the village, if you use the self-priming pump with a pressure tank, there should be no problem when the water is supplied in the village, but once the water supply is stopped in the village, the pressure is reduced, and the self-priming pump will start, so is the self-priming pump dry pumping but unable to pump water? >>>More
Check whether the angle valve in the cabinet is opened to the maximum.
Adding a check valve to the water inlet of the water heater will solve the problem, that is, the water pressure is low there, or the water heater is too sensitive.
It is good for the toilet bowl and easy to break down for the basin cabinet.