-
Anonymous users2024-01-23Rotate to the left, twist, and remove the hose from the halter! Go to the building materials store and buy a seal! Just seal the opening! Don't cut it with a saw!
-
Anonymous users2024-01-22Cut it with a tool, generally with a chainsaw, and then block it with a wire plug.
-
Anonymous users2024-01-21Turn off the sluice of this pipe, unscrew the growing part with a pipe wrench, and then take the grown part and go to the building materials market to buy a plug.
-
Anonymous users2024-01-20Keep the tube short and attach the switch. Turn off the faucet. Cover with a cabinet.
-
Anonymous users2024-01-19You can turn off the source, break the interface, and connect a sealed water pipe head, and you're good to go.
-
Anonymous users2024-01-18From the image, you can see a section of extended steel pipe exposed outside, and the window side is a car wire, you just need to use a pipe wrench to unscrew it, and compare the water pipe to buy the same wire to block the car.
-
Anonymous users2024-01-17Turn off the main valve....Plug the ...... with a plugThe easiest way.
The sewer pipe does not need to be blocked, and there is no water if the water is not released.
After the use of housing, the problem of freezing in the thawing pipe only plays a temporary role, and it is impossible to carry out the thawing work often, and it is necessary to keep warm to prevent freezing, especially in severe cold areas. >>>More
These two musts, but also install a floor drain (drainage). >>>More
The balcony water pipe should be passed from the living room, and the water pipe can be connected to the balcony before decorating the floor. . . Nowadays, home decoration is water pipes and circuit pipes from the ground to the places where they are needed, and then the floor tile construction is carried out, which is both beautiful and practical. However, before decoration, the water pipe pressure test must be carried out to avoid leakage.
Close the main gate and change the water pipe.