-
Anonymous users2024-01-23There is a simple bai
Solution: Prepare a glass top as long as your glass top
5-8 cm DAO glass strip on one side.
On the top of the inner sun, one side is placed on the wall and fixed with glue (be sure to use structural glue, ordinary glass glue is not good, it is too easy to age) If you think it is ugly, you can directly put 3 cm glass strips on the wall cracks.
-
Anonymous users2024-01-22(3) Permeable crystalline waterproof coating (SH-103).
Features: Strong adhesion to the substrate.
The capillary pores that can penetrate into the cement substrate in the active ingredient of the slurry are integrated with the substrate to form a crystalline dense waterproof layer, which can be applied on a wet base layer.
Application: Waterproof and seepage prevention projects such as indoor and outdoor walls, toilets, grounds, basements, roofs, pools, ditches, etc. of indoor and outdoor civil buildings in various places.
Performance: Powder and water are melted and stirred evenly for use, (1) for brushing: powder and water = 25:8, can be coated with one layer for moisture-proof, and can be coated with two layers for waterproofing.
-
Anonymous users2024-01-21"This Trouble" is the original Bai first in the installation of glass.
du, the connection with the wall, the waterproofing process dao improper treatment. General.
version of the solution is still more convenient outside the right room. It can also be handled indoors, but the practice must be in place:1; Remove the original glue and impurities from the glass and wall, 2;Make sure the glass is completely disconnected from the wall (the gap is about 1cm)3; Clean the wall at the gap to ensure that the outer layer of the wall (such as concrete powder) is intact, 4;Glue from the room up with weather-resistant sealant (main points:
1> When encountering steel frames or aluminum alloy frames, be sure to be above them. <2> Paste masking paper at 30mm on the glass edge, < 3> glue starts from the wall, after playing a layer, touch it with a small scraper, so that the glue is fully glued with the wall, the glue layer is 50mm higher than the glass, and the glue layer laps the glass 30mm. ）
The first is that the strength is several times higher than that of ordinary glass, the flexural strength is 3 5 times that of ordinary glass, and the impact strength is 5 10 times that of ordinary glass, which improves the strength and safety at the same time. The second is the safety of use, its bearing capacity is increased to improve the fragile properties, even if the tempered glass is damaged, it is a small fragment without acute angles, and the damage to the human body is greatly reduced. The resistance of tempered glass to quenching and heating is 2 3 times higher than that of ordinary glass, and it can generally withstand tempered glass. >>>More
There are various colors on the balcony, if the balcony is on the top, it is recommended to use 10-20 tempered to be safer, and ordinary glass is easy to burst when the wind blows and the sun for a long time. The edge can also choose tempered glass, which is not easy to break, as long as it is not smashed. The slightest smash of ordinary glass can burst and it is also easy to injure people. >>>More
No problem. OK.
It can play a role in protecting privacy. >>>More
One hundred percent... 1000000
Tempered glass is made of ordinary glass after high-temperature processing and cooling, and its hardness is twice that of ordinary glass, so tempered glass is also called safety glass. One is because the tempered glass becomes granular after it is broken, and the other is because the toughness of the tempered glass is not easy to break. Therefore, tempered glass is mandatory by the state to implement safety signs, and each piece of tempered glass must have a national security "3C" mark. >>>More