-
Anonymous users2024-01-24Just press the switch.
-
Anonymous users2024-01-23Pumei multi-control switch is good, one is installed at the head of the bed, one is installed at the door, no need for separate wiring, and the control signal is transmitted by the zero line of the live wire, which is very powerful.
First of all, the wire head in the junction box is treated with adhesive tape, and then buy a waterproof switch box on the switch, and it will be fine to close the waterproof box when taking a bath at night, and you can buy it at the hardware store. Buy a better one, about ten yuan.
If there is no impact, don't pay attention to it, if there are any faults about the water, then install it yourself and try it, buy a few dollars, this kind of thing can be called by the landlord to come and repair and maintain.
Flat screwdriver, insert the flat groove at the bottom and the mask falls off, and then use a torx screwdriver to remove the two set screws.
1. First of all, you need to use a test pen to confirm which one is the live wire, so that the remaining 2 are the ground wire (zero judgment line); Secondly, 2 ground wires are connected to the lower ends of 2 binding posts; Finally, simply connect the live string to the upper end of the two binding posts. It should be reminded that before wiring, it is necessary to ensure that the main switch is disconnected. >>>More
There are two lines that are spare.
You can see that there are two according to the line of fire, one is the zero line, and one is the bottom line. >>>More