-
Anonymous users2024-01-24The design is monoamine, and there is no double press to say one, which is easy to damage the buttons. Therefore, you should develop the habit of pressing alone.
-
Anonymous users2024-01-23The rubber sealing ring is in the water tank, the upper plane of the water outlet of the water tank. When installing, it is necessary to wipe the rubber ring and sealing surface. Fastening is fine: If it is a problem with poor bonding sealing, it is recommended that you use a little glass sealant.
Hello! This should not be a problem with the water tank, but a problem with the flushing method, some early siphon toilet flushing efficiency is not high, and it is not as good as direct flushing.
See if the filter is clogged.
Solution: Close the valve on the hose connecting to the water inlet of the tank. Flush the toilet again and drain the remaining water from the tank. >>>More
If the middle of the tank lid is a button switch, use a tool to clamp the outside of the button switch, turn counterclockwise, remove the button, the tank lid can be opened, and if the tank lid can be lifted.
Try turning off the tap water, draining the water, letting the air in, and then turning on the tap water.
The principle of automatic flushing of toilets:
There is a float valve inside, as the water level in the tank rises, the buoyancy generated by the float increases, and when the water level rises to a predetermined value, the buoyancy generated by the float will be transmitted to the plug that discharges the water through a seesaw structure, and the plug can be automatically pulled up as long as the drain button is pressed. After the water is discharged, the plug automatically returns to its position under the action of the spring and enters the next round of water filling cycle. >>>More