-
Anonymous users2024-01-241.If the port on the router facing this room is loose or broken, unplug it and plug it in again or change the port. 2.The network cable from the room socket to the router is faulty, the cables and connectors may be broken, and the general cable is not very likely to be broken, and the head can be broken and redone.
You swap the ports on the router with those in the living room and see what the problem is.
-
Anonymous users2024-01-23Reset the router, or unplug it and wait for 15 minutes before plugging it in, if it still doesn't work, the bridge is broken and the router is replaced.
My bathtub is a power cord made of network cables, and the two strands are combined into one strand and started to use, and the 8-core network cable goes through the 100-watt heating rod and the 12-watt water pump at the same time. Anyway, your five meters is a bit long, but the bulb is only 40 watts, it shouldn't be a big problem.
It is a problem with the settings of your router equipment, and the dial-up connection settings are not set up, resulting in the inability to connect to the wifi network normally. >>>More
My suggestion is to raise two pots of pothos, or spider plants, because they are easy to maintain and can purify the air in the house.
Each port of the home network is separated by weak wires in the home,,, the cat and the router are installed in the weak current phase,,, and each port is connected through the router.
After setting the WAN port of route b to automatically obtain the IP, you also need to set the Lan port to, otherwise the mobile phone behind router b will not be able to recognize the two routers b and a because their IP addresses conflict. After setting, some mobile phones need to reconnect to the b router because the IP address of the mobile phone will change.