-
Anonymous users2024-01-241. Clean with hot water, buy some wind oil essence or toilet water after washing, open the lid and put it in the corner of the bathroom2. Find the smelly pipes If you don't use them, plug them with pipes! It is also recommended to replace it with a submarine floor drain, but the key is to fill the floor drain frequently, one is to replace the odorous old water, and the other is to form enough water seal to block the conduction path of odor in the sewer.
3. Change the bathroom with fresh air, open the window or turn on the exhaust fan.
4. Put the food or sand you don't eat in a plastic bag, put it on the sewer mouth, cover the odor 5, cut the bottom of the thin plastic bag, and make it into a tube with upper and lower energy, and then put one end in the sewer, and wrap the other end on the cover, when there is water, the water will wash the plastic bag away, and when there is no water, the plastic bag will naturally close.
6. After eating the glaze, put the glaze skin into the pot (it is best to cut the glaze skin into small pieces), add an appropriate amount of water, turn off the heat after the water is boiled, take out the glaze skin, the key is to use the glaze water in the pot, and then pour the glaze water into the sewer of the bathroom, and the smell will be gone.
-
Anonymous users2024-01-23It can only be ventilated frequently. Or add fragrance to the ornaments.
This is basically fixed: a 100mm tube can be walked around. Some sides can be changed with small tubes.
In modern home decoration, the bathroom is not only a place to wash off the dust, but also a place to relax the nerves and rejuvenate the floor. Therefore, instead of thinking of the bathroom as the most unclean part of the room, as in the past, it should be carefully planned. Today I will tell you how to install the bathroom drain. >>>More
Be sure to do a good job of drainage. 1. The water pipe is a hidden project, and the size of the water pipe must be considered more comprehensively when arranging the size of the water pipe, or it is not easy to use in the later stage, and it is more troublesome to maintain. Toilet drain pipe size: The inner diameter of the sewer pipe is 100mm to 3000mm, and the length is 30mm to 200mm. >>>More
First of all, consider whether the above branch pipes have a simultaneous drainage process, if there is no DN50 pipe is absolutely insufficient, it is recommended to thicken to DN63 (PVC) pipe or thicker. As for the phenomenon of oil pollution plugging pipe, it is difficult for PVC pipe to occur, because the surface finish of PVC pipe is very good, and it is easy to dredge, easy to construct and low cost, so it is the preferred material for water supply and discharge. If it is connected to the DN100 pipe, the main pipe after the confluence of the three branch pipes above also needs the DN63 pipe, which is more certain.