-
Anonymous users2024-01-24The toilet flush is not enough, and the toilet is not flushed clean, which may be a problem with the toilet shifter, that is, the water outlet of the toilet is not directly facing the sewer pipe, and there is a curve in the middle, which is connected when the toilet is installed. It is also possible that the toilet is blocked, after the toilet is blocked, when flushing, the water level will slowly rise, and the toilet will not be flushed. It is also possible that when you use it, you don't have a good reason to do it, and you don't let go when you press the flush button, which will also cause the impulse to be insufficient, and you must press it for 2-3 seconds, so that you can completely open the flush valve, and the flushing effect can be the best.
-
Anonymous users2024-01-231. Increase the water level of the water tank.
2. Increase the height of the water tank.
-
Anonymous users2024-01-22I can raise the water level of the tank.
There is no other good way.
-
Anonymous users2024-01-21Put a bucket next to the toilet, store the waste water from washing vegetables and laundry in the bucket, and then use the water in the bucket to flush the toilet, which saves water and greatly enhances the flushing power of the toilet.
The water volume switch of the toilet tank is controlled by the float, you only need to adjust the connecting rod of the float to the position where the water level of the tank is the highest and will not overflow.
Go to the small commodity market and spend 5 yuan, buy a leather tiger (suction pump), release the water and suck it yourself, and it will be smooth.
Do you live on the first floor? Or is your toilet a converted from the original squat pit? If such a toilet does not have a punch, there is nothing to be done.
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
The siphon flush toilet is not flushed enough.
Siphon toilet flush enough >>>More