-
Close the water valve on the back of the toilet bowl and drain the water in the toilet. To fix a leaky base, it is also possible to take down the entire toilet tank.
-
The base leakage should first remove the toilet, close the water pipe first, first solve the cause of the leakage after removing the toilet, and then wipe the ground clean with a cadre, and then put the toilet on it, and the sealing ring of the sewer pipe is tightly connected, the toilet is placed, and then start spraying glass glue after it is stable and does not shake, and the toilet can not be used for 24 hours after the glue is made, and it can be used after 24 hours, you have water leakage, which proves that the cause of the leakage has not been solved, so you have to solve the cause of the leakage first.
-
If it is not installed, reinstall it, wipe it clean with a towel, and neutral glass glue is the best.
-
Use a plastic broom to sweep the water to the drain and you're good to go.
-
Blot with paper! Blow with a hair dryer afterwards.
With the continuous improvement of people's living standards, the toilet has become an indispensable household item in every family, but after a long period of use, there may be a leakage of the toilet base, so what to do if the toilet base is leaking? What should I pay attention to when making glass glue at the bottom of the toilet? Let's take a look! >>>More
This can be cleaned up and redone, taking care to clean it up and free of water and dust.
Causes of water seepage on the edge of the toilet: The toilet bowl is not tightly sealed between the drain and the toilet downpipe. >>>More
The base of the toilet bowl usually has a sealing ring, perhaps it is aging, replace a sealing ring, and then seal the gap with glass glue.
The analysis based on your simple description is as follows: >>>More