-
Anonymous users2024-01-23There is running water, and it is necessary to determine the source of the water. Whether the waterproof layer is damaged or not, it doesn't feel so easy to discern. Don't move the tiles yet, look for possible locations where water seeps from above.
It is best to let an experienced person check it for you, and it is best to use an instrument to detect it to avoid damaging the tiles and causing more trouble.
I haven't seen it yet.
The shower room water retaining strip is generally made of marble, granite, and black sand marble. However, it should be noted that if it is a light-colored ground, black sand marble will affect the appearance, and the light-colored ground can be built with floor tiles to build a platform on the ground, which is both beautiful and will not leak. >>>More
The height that extends from the floor to the wall according to the specification is generally 30 cm; If there is a shower room, the wall near the shower faucet should have a brush height of not less than 150 cm for waterproof coating. 100MM is not enough.
24 hours, after the waterproof layer is made, wait until the material is dried to the specified time, and do a closed water test. >>>More
When the waterproofing is done, pockets are formed, and leaking water is stored there, and if there is too much, it seeps out from walls, floors, etc., and water stains are formed. or from a gap in the pipe to the next layer. Therefore, it can be used as a drainage pipe inside.
The toilet is generally not large, the sinking is 10-20 cm, the amount of backfill is not large, as long as it can be waterproof and crack-proof, it is OK to use brick slag to mix concrete. The clay is not as hard as the brick slag, but it can still be used, and the clay is very cheap, about twenty pieces.