-
Anonymous users2024-01-24There is no damage to the wall surface of the floor tiles with a small amount of water on the floor tiles, and the air can be dipped in some water with a mop to drag on the ground, and there is no need to splash water.
-
Anonymous users2024-01-23There shouldn't be any big problems, but you can raise some flowers, put a plate of water or something, and there will be no hidden dangers at the same time!
-
Anonymous users2024-01-22Generally speaking, there is no problem, but this should also be seen by the material you put on the brick, if the material is not up to standard, it is difficult to say, if you pass, there is no big problem.
-
Anonymous users2024-01-21As long as you don't splash too much, it's fine, and it has no effect on the floor tiles.
-
Anonymous users2024-01-20As long as the material you use is qualified, splashing a little water will not have any effect on the tile itself, nor will it affect the combination of the tile and the wall, but it is possible that the water will seep through the gap in the tile, which will have a negative impact on the wall or the top of your neighbor's house, leaving unsightly water marks on the latex paint layer!! So it is advisable not to splash water, just use a wet mop to mop it!!
-
Anonymous users2024-01-19It's not a big problem if the amount of water is small, but if there is more, it may seep downstairs or slide to yourself. I think it is feasible to buy a larger carpet (chemical fiber) to wet and spread it indoors, or put wet towels on the radiator to hang wet clothes, and the easiest way is to buy a humidifier.
-
Anonymous users2024-01-18There's no need to splash water at all, since you splash water, it's okay, and a little water in the tile gap is fine, you can rest assured that it's okay.
-
Anonymous users2024-01-17No problem.
However, the problem of dampness can be taken into account.
As long as the quality and construction are passed, there is no problem with a little bit of water.
-
Anonymous users2024-01-16It depends on the material used in tiling, and the composition of cement.
As far as the comparison between the two is concerned, it is better to choose ceramic tiles. >>>More
Is it because your family has been renovating the house recently that you have such a dream?
Here the source of the thickness of the floor in your living room is actually from your bathroom, there are regulations in the brick-laying process, that is to say, the floor drain in your bathroom is the lowest point of your home, where the thickness of the cement mortar layer must be kept above the centimeter, which is the foundation. The renovation process of your bathroom must have a slope. In this way, the door of your bathroom is also high, and your hall is positioned on this basis with the amount of cement and sand, which is flat or slightly higher than the door of the bathroom. >>>More
If it is a vitrified brick, it is the kind of surface that is smooth, you can go to the hotel supply store to buy some oxalic acid and wash it back to ensure that it is bright! Moreover, oxalic acid is very cheap, less corrosive than other acidic detergents, and has a good effect.
Whether it is the first to paste the floor tiles or the first wall tiles are OK, the first to pave the floor tiles or the first to lay the wall tiles, need to be decided according to the specific situation of the resident's home decoration, mainly to paste the floor tiles or wall tiles to carry out reasonable protection of the construction project, paste the wall tiles need to pay attention to the level and right angle between each tile must be done. When the floor tiles are laid, they should be subsidized in a parallel way on the side of the wall, and the brick joints should be aligned and no joints should be left.